Range Rover: Restricted seat travel
NOTICE
If seat movement stops unexpectedly during adjustment, check for and remove any obstructions.
Once any obstructions have been removed, the seat adjustment mechanism can be reset as follows:
Operate the button again, to continue the stalled adjustment, and hold in that position for 2 seconds. When seat movement resumes, hold the button until the end of travel in that direction has been reached. Seat adjustment can now be carried out as normal.
Note: If no obstructions can be seen, but normal adjustment cannot be carried out without stalling, contact your Land Rover Retailer/Authorized Repairer.
Electric seats
WARNING
Do not adjust the seat while the vehicle is moving. Doing so could cause loss
of vehicle control and personal injury.
1. Bolster adjustment:
A. Bolster inflate.
B. Bolster deflate ...
Sitting in the correct position
WARNING
Riding with a reclined seatback increases your chance of serious or fatal injuries
in the event of a collision or sudden stop. The protection of your restraint system
(seat belts and ...
See also:
Rear-facing child restraint installation using the seat belts
WARNING
► The three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure
to use the ALR mode will result in the
child restr ...
Replacement sensor
Should the sensor require replacing, it should be carried out by a Land Rover
Retailer/ Authorized Repairer.
A replacement sensor must be fitted to a running wheel in order to be recognized
by th ...
Removing the vehicle battery
WARNING
Switch the ignition off before disconnecting battery terminals.
Always disconnect the negative terminal first and reconnect last.
Use caution when lifting the battery out of, or into, ...
