Range Rover: Grass/gravel/snow - Terrain response - Range Rover Owner's ManualRange Rover: Grass/gravel/snow

This program should be used where a firm surface is covered with loose or slippery

This program should be used where a firm surface is covered with loose or slippery material.

Note: For deep gravel it is recommended that the Sand program is selected.

Note: If the vehicle is unable to gain traction in deep snow, switching DSC off may help. DSC should be switched on again as soon as the difficulty is overcome.

    General program (special programs off)
    This program is compatible with all on and off-road conditions. If not already active, it should be selected before driving on surfaces which are similar to a hard road surface. Dry cobbles, tar ...

    Mud-ruts
    This program should be used for crossing terrain that is muddy, rutted, soft or uneven. Low range is recommended for this program and if not selected, the message center will prompt you. If th ...

    See also:

    Replacing the Engine Air Cleaner/ Filter
    1. Locate the air cleaner/filter assembly. See Engine Compartment Overview  . 2. Loosen the four screws on the cover of the housing and lift up the cover. 3. Remove the engine air cleaner/ ...

    Tire changing
    Always have your tires serviced or changed by a qualified technician. Care must be taken to avoid contact between the bead of the tire and the sensor during removal and refitting of the tire, other ...

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds) ...