Mercedes-Benz GL-Class: Safety guidelines for seat belts,Emergency Tensioning Devices (ETDs)and air bags - SRS (Supplemental Restraint System) - Occupant safety - Safety - Mercedes-Benz GL-Class Owner's ManualMercedes-Benz GL-Class: Safety guidelines for seat belts,Emergency Tensioning Devices (ETDs)and air bags

WARNING • Damaged seat belts or seat belts 
Damaged seat belts or seat belts that have been subjected to stress in an accident must be replaced. Their anchoring points must also be checked. Only use seat belts installed or supplied by an authorized Mercedes-Benz Center.
Air bags and pyrotechnic Emergency Tensioning Devices (ETDs) contain perchlorate material, which may require special handling and regard for the environment. Check your national disposal guidelines. California residents, see www.dtsc.ca.gov/HazardousWaste/ Perchlorate/index.cfm.
Air bags and ETDs are designed to function on a one-time-only basis. An air bag or ETD that has deployed must be replaced. PRESAFE ® has electrically operated reversible belt tensioners in addition to the pyrotechnic ETDs.
Do not pass seat belts over sharp edges.
They could tear.
Do not make any modification that could change the effectiveness of the seat belts.
Do not bleach or dye seat belts as this may severely weaken them. In a crash they may not be able to provide adequate protection.
No modifications of any kind may be made to any components or wiring of the SRS.
Do not change or remove any component or part of the SRS.
Do not install additional trim material, seat covers, badges, etc. to the:
- padded steering wheel boss
- knee bag covers
- front-passenger air bag cover
- outer side of front seat bolsters
- outer side of rear bench seat backrest seat bolsters
- roof lining trim
Do not install additional electrical/electronic equipment on or near SRS components and wiring.
Keep area between air bags and occupants free of objects (e.g. packages, purses, umbrellas, etc.).
Do not hang items such as coat hangers from the coat hooks or handles over the door. These items may be thrown around in the vehicle and cause head and other injuries when the window curtain air bag is deployed.
Air bag system components will be hot after an air bag has inflated. Do not touch them.
Never place your feet on the instrument panel, dashboard, or on the seat. Always keep both feet on the floor in front of the seat.
Improper repair work on the SRS creates a risk of rendering the SRS inoperative or causing unintended air bag deployment.
Work on the SRS must therefore only be performed by qualified technicians.
Contact an authorized Mercedes-Benz Center.
For your protection and the protection of others, when scrapping the air bag unit or ETD, our safety instructions must be followed. These instructions are available from any authorized Mercedes-Benz Center.
Given the considerable deployment speed, required inflation volume, and the material of the air bags, there is the possibility of abrasions or other, potentially more serious injuries resulting from air bag deployment.

If you sell your vehicle, Mercedes-Benz strongly recommends that you inform the subsequent owner that the vehicle is equipped with SRS. Also, refer them to the applicable section in the Operator's Manual.

    SRS warning lamps
    SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time. The SRS warning lamp in the instrumen ...

    Air bags
    ...

    See also:

    Capacities and recommended fuel/lubricants
    The following are approximate capacities. The actual refill capacities may be a little different. When refilling, follow the procedure instructed in the “8. Maintenance and do-it-yourself” sec ...

    Driving Characteristics and Towing Tips
    WARNING The driver can lose control when pulling a trailer if the correct equipment is not used or the vehicle is not driven properly. For example, if the trailer is too heavy, the brakes may not ...

    Topping up the oil
    Your vehicle warranty may be invalidated if damage is caused by using oil that does not meet the required specification. Failure to use an oil that meets the required specification could cause exce ...