Infiniti QX: Replacing
Replace the wiper blades if they are worn. 1. Pull the wiper arm. 2. Push the release tab A , and then move the wiper blade down the wiper arm 1 while pushing the release tab to remove. 3. Insert the new wiper blade onto the wiper arm until a click sounds. 4. Rotate the wiper blade so the dimple is in the groove.
CAUTION
► After wiper blade replacement, return
the wiper arm to its original position;
otherwise it may be damaged when the
hood is opened.
► Make sure the wiper blades contact the
glass; otherwise the arm may be damaged
from wind pressure.
Be careful not to clog the washer nozzle A . This may cause improper windshield washer operation. If the nozzle is clogged, remove any objects with a needle or small pin B . Be careful not to damage the nozzle.
Cleaning
If your windshield is not clear after using
the windshield washer or if a wiper blade
chatters when running, wax or other
material may be on the blade or windshield.
Clean the outside of the w ...
Rear window wiper blades
Contact an INFINITI retailer if checking or
replacement is required. ...
See also:
General notes
USA only:
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. this device mus ...
Entry and exit mode
With the steering column control (1) in the AUTO position, the steering column
and driver’s seat will move to provide easier entry and exit from the vehicle.
On opening the driver’s door the sy ...
Speed-dependent mode
If vehicle speed drops below 5 mph (8 km/h) with the wipers operating, the wipers
will switch to the next lowest speed. When vehicle speed increases to over 5 mph
(8 km/h), the original wiper spee ...
