Infiniti QX: Rear window wiper and washer switch
WARNING
In freezing temperatures the washer solution
may freeze on the rear window glass
and obscure your vision. Warm the rear
window with the defroster before you wash
the rear window.
CAUTION
► Do not operate the washer continuously
for more than 30 seconds.
► Do not operate the washer if the
reservoir tank is empty.
► Do not fill the window washer reservoir
tank with washer fluid concentrates at
full strength. Some methyl alcohol
based washer fluid concentrates may
permanently stain the grille if spilled
while filling the window washer reservoir
tank.
► Pre-mix washer fluid concentrates with
water to the manufacturer’s recommended
levels before pouring the fluid
into the window washer reservoir tank.
Do not use the window washer reservoir
tank to mix the washer fluid concentrate
and water.
If the rear window wiper operation is interrupted by snow etc., the wiper may stop moving to protect its motor. If this occurs, turn the wiper switch to OFF and remove the snow etc. on and around the wiper arms. After about 1 minute, turn the switch ON again to operate the wiper.
The rear window wiper and washer operate when the ignition switch is in the ON position. Turn the switch clockwise from the OFF position to operate the wiper.
1 Intermittent (INT) — intermittent operation
(not adjustable)
2 Low (ON) — continuous low speed
operation
Push the switch forward3 to operate the washer. Then the wiper will also operate several times.
Rain-sensing auto wiper system
The rain-sensing auto wiper system can automatically turn on the wipers and adjust the wiper speed depending on the rainfall and the vehicle speed by using the rain sensor located on the upp ...See also:
Deactivating the alarm when triggered
If the alarm has been triggered it can be deactivated by pressing the Smart Key
unlock button, or by positioning the Smart Key underneath the steering column (see
74, IF THE ENGINE FAILS TO START) ...
Wheel Alignment and Tire Balance
The tires and wheels were aligned and balanced at the factory to provide the
longest tire life and best overall performance. Adjustments to wheel alignment and
tire balancing will not be necessary o ...
Adjusting the headlamps
1 V vertical axis
2 H (horizontal) height, measured from the
center
Setting the headlamps correctly is extremely
important. Setting the high-beam headlamps
also sets the low-beam headlamps. (Th ...