Range Rover: Quick poi selection
Touch the Map screen to display the POI button. Touch the POI (Point of interest) button. The screen shows six suggested categories, five of which can be selected as quick points of interest.
Note: The POI icons will not be shown if the map zoom level is greater than ½ mile (1 km). Select a Quick POI category, or select More to see further POIs. Touch OK to confirm a selection.
The map screen with the POI icon(s) is displayed. Select the five POIs you wish to see when the Quick POIs are displayed.
Cancel route guidance
To stop route guidance, proceed as follows:
1. Touch Nav menu on the map menu screen.
2. Touch the Cancel guidance soft key. ...
Restore system defaults
If you have made any changes to the system’s default settings, use this menu
to restore the original settings. ...
See also:
Storing the current speed or calling upthe last stored speed
WARNING
The set speed stored in memory should only
be set again if prevailing road conditions and
legal speed limits permit. Possible
acceleration or deceleration differences
arising ...
Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire
(Not Punctured)
To use the air compressor to inflate a tire with air only and not sealant:
If a tire goes flat, avoid further tire and wheel damage by driving slowly to
a level place. Turn on the hazard warning f ...
Sand
This program should be used for terrain which is predominantly soft dry sand
or deep gravel.
Note: If the vehicle is unable to gain traction in extremely soft, dry sand,
switching DSC off may h ...
