Infiniti QX: How to switch the display
The Around View Monitor display consists of the left and the right screens. You can see a combination of different views on the screens as illustrated above.
Starting with the selector lever operation
► When the selector lever is shifted into
the R (Reverse) position 1 while
another screenA is displayed, Around
View Monitor operates and the rearview
and bird-eye view B are displayed.
The Around View Monitor screen
switches to the previous screen when
the selector is shifted out of the R
(Reverse) position 2 .
► The view on the screen on the passenger’s
side switches to the front-side
view C when the CAMERA button is
pushed 3 . When the CAMERA button
is pushed again5 , the rear-wide view
D is displayed. When the CAMERA
button is pushed again7 , the view on
the screen on the passenger’s side
switches to the bird-eye view B .
The passenger’s side screen returns to
another by operating the same procedures
again.
When selecting the “Wide”, “Side” or
“Top” key on the screen using the
INFINITI controller and pushing the
ENTER button, the view on the screen
will change to the one previously
selected 4 , 6 , 8 .
► Once you have changed the view on the
screen on the passenger’s side, the
view on the driver’s side will change to
the front view by shifting the selector
lever out of the R (Reverse) position12 ,
14 .
When the selector lever is moved to any
other position than the R (Reverse)
position while the rear-wide view D
is displayed, another view that is set to
a higher priority will be displayed 16 .
Starting with the CAMERA button operation
► When the CAMERA button is pushed 9
while another screen A is displayed,
Around View Monitor operates and the
front view and bird-eye view E are
displayed.
► The view on the screen on the passenger’s
side switches to the front-side
view F when the CAMERA button is
pushed 10 . When the CAMERA button
is pushed again 17 , the screen A is
displayed.
► When selecting the “Side” or “Top” key
on the screen using the INFINITI controller
and pushing the ENTER button,
the view on the screen will change to
the one previously selected 11 .
► The left screen switches to the rearview
B , C when the selector lever is
shifted into the R (Reverse) position 13 , 15 and returns to the front view
E , F when the selector lever is
shifted out of the R (Reverse) position
12 , 14 .
► Push another button on the control
panel to quit the Around View Monitor.
Around ViewTM Monitor
When you push the CAMERA button or shift the selector lever into the R (Reverse) position while the ignition switch is in the ON position, the Around View Monitor operates. The monitor display ...How to see each view
WARNING ► The distance guide line and the vehicle width line should be used as a reference only when the vehicle is on a paved, level surface. The distance viewed on the monitor is fo ...See also:
Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass.
If the headlamps are off or in the low-beam position, pull the turn signal lever
toward you to momentarily switch to high ...
System maintenance
► The two radar sensor units 1 for the
BSW and Blind Spot InterventionTM
systems are located near the rear
bumper. Always keep the area near
the radar sensors clean. Do not attach
st ...
Cleaning exterior
In order to maintain the appearance of
your vehicle, it is important to take proper
care of it.
To protect the paint surface, wash your
vehicle as soon as you can:
► after a rainfall t ...