Infiniti QX: HomeLink® Universal Transceiver
HomeLink® Universal Transceiver provides
a convenient way to consolidate the functions
of up to three individual hand-held
transmitters into one built-in device.
HomeLink® Universal Transceiver:
► Will operate most Radio Frequency (RF)
devices such as garage doors, gates,
home and office lighting, entry door
locks and security systems.
► Is powered by your vehicle’s battery. No
separate batteries are required. If the
vehicle’s battery is discharged or is
disconnected, HomeLink® will retain all
programming.
Once HomeLink® Universal Transceiver is
programmed, retain the original transmitter
for future programming procedures
(Example: new vehicle purchases). Upon
sale of the vehicle, the programmed
HomeLink® Universal Transceiver buttons
should be erased for security purposes.
For additional information, see “Programming
HomeLink®” later in this section.
WARNING
► Do not use HomeLink® Universal Transceiver
with any garage door opener that
lacks safety stop and reverse features as
required by federal safety standards.
(These standards became effective for
opener models manufactured after April
1, 1982.) A garage door opener which
cannot detect an object in the path of a
closing garage door and then automatically
stop and reverse, does not meet
current federal safety standards. Using a
garage door opener without these features
increases the risk of serious injury
or death.
► During programming procedure, your
garage door or security gate may open
or close. Make sure that people and
objects are clear of the garage door,
gate, etc. that you are programming.
► Your vehicle’s engine should be turned
off while programming HomeLink® Universal
Transceiver.
- Programming HomeLink®
- Programming HomeLink® for Canadian customers
- Operating the HomeLink® Universal Transceiver
- Programming trouble-diagnosis
- Clearing the programmed information
- Reprogramming a single HomeLink® button
- If your vehicle is stolen
Cargo light
The cargo light switch has three positions:
ON 1 , center 2 and OFF 3 .
ON position
When the switch is in the ON position 1 ,
the cargo light will illuminate.
Center position
When the sw ...
Programming HomeLink®
To program your HomeLink® Universal
Transceiver to operate a garage door, gate,
or entry door opener, home or office
lighting, you need to be at the same
location as the device. Note: Garage ...
See also:
Topping up the brake fluid
NOTICE
Brake fluid will damage painted surfaces. Soak up any spillage with an absorbent
cloth immediately and wash the area with a mixture of car shampoo and water.
Only use new fluid from an ...
Fuel gauge
The gauge indicates the approximate fuel
level in the tank.
The gauge may move slightly during
braking, turning, acceleration, or going up
or down hills.
The gauge needle returns to 0 (Emp ...
Glare from the side
► Fold down sun visor 1.
► Pull sun visor 1 out of retainer 3.
► Swing sun visor 1 to the side.
► Vehicles with a sliding sunroof: slide sun
visor 1 horizontally as desir ...