Buick Enclave: Engine Overheating
The vehicle has several indicators to warn of engine overheating.
There is an engine coolant temperature gauge on the instrument panel cluster.
See Engine Coolant Temperature Gauge .
The vehicle may also display an ENGINE OVERHEATED IDLE ENGINE and ENGINE OVERHEATED STOP ENGINE message in the Driver Information Center (DIC). See Engine Cooling System Messages .
You may decide not to lift the hood when this warning appears, but instead get service help right away.
See Roadside Assistance Program (U.S. and Canada) or Roadside Assistance Program (Mexico) .
If you do decide to lift the hood, make sure the vehicle is parked on a level surface.
Then check to see if the engine cooling fans are running. If the engine is overheating, both fans should be running. If they are not, do not continue to run the engine and have the vehicle serviced.
Notice: Engine damage from running the engine without coolant is not covered by the warranty.
Notice: If the engine catches fire while driving with no coolant, the vehicle can be badly damaged.
The costly repairs would not be covered by the vehicle warranty. See Overheated Engine Protection Operating Mode for information on driving to a safe place in an emergency.
If Steam Is Coming from the Engine Compartment
WARNING
Steam from an overheated engine can burn you badly, even if you just open the
hood. Stay away from the engine if you see or hear steam coming from it. Turn it
off and get everyone away from the vehicle until it cools down.
Wait until there is no sign of steam or coolant before you open the hood.
If you keep driving when the vehicles engine is overheated, the liquids in it can catch fire.
You or others could be badly burned. Stop the engine if it overheats, and get out of the vehicle until the engine is cool.
See Overheated Engine Protection Operating Mode for information on driving to a safe place in an emergency.
If No Steam Is Coming from the Engine Compartment
If an engine overheat warning is displayed but no steam can be seen or heard, the problem may not be too serious. Sometimes the engine can get a little too hot when the vehicle:
► Climbs a long hill on a hot day . Stops after high-speed driving . Idles for long periods in traffic . Tows a trailer If the overheat warning is displayed with no sign of steam:1. Turn the air conditioning off.
2. Turn the heater on to the highest temperature and to the highest fan speed. Open
the windows as necessary.
3. If in a traffic jam, shift to N (Neutral); otherwise, shift to the highest gear
while driving—D (Drive) or L (Low).
If the temperature overheat gauge is no longer in the overheat zone or an overheat warning no longer displays, the vehicle can be driven.
Continue to drive the vehicle slow for about 10 minutes. Keep a safe vehicle distance from the car in front of you. If the warning does not come back on, continue to drive normally.
If the warning continues, pull over, stop, and park the vehicle right away.
If there is no sign of steam, idle the engine for three minutes while parked. If the warning is still displayed, turn off the engine until it cools down. Also, see “Overheated Engine Protection Operating Mode” next in this section.
Engine Coolant
The cooling system in the vehicle is filled with DEX-COOL® engine coolant. The coolant is designed to remain in the vehicle for 5 years or 240 000 km (150,000 mi), whichever occurs first. The fo ...Overheated Engine Protection Operating Mode
This emergency operating mode lets the vehicle be driven to a safe place in an emergency situation. If an overheated engine condition exists, an overheat protection mode which alternates firing gr ...See also:
Direction indicator bulb replacement
1. Twist and lift off the cap.
2. Press the catches and pull the bulb holder from the unit.
3. Push and twist to remove the bulb. ...
Returning the Seatback to the Upright Position
To return the seatback to the upright position:
1. Open the liftgate to access the controls for the seat.
2. Raise the seatback to the upright position.
WARNING
If either seatback is not locke ...
Type approval numbers
The TPMS devices comply with part 15 of the FCC rules and IC - RSS-210. Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this devic ...