Range Rover: Changing a bulb - Maintenance - Range Rover Owner's ManualRange Rover: Changing a bulb

NOTICE NOTICE

CAUTION: Before attempting to replace a bulb, ensure that both the affected lamp CAUTION: Before attempting to replace a bulb, ensure that both the affected lamp and the vehicle’s ignition are turned off. If the circuit remains live, a short circuit can occur which may damage the vehicle’s electrical system.

CAUTION: Always replace bulbs with the correct type and specification. If you CAUTION: Always replace bulbs with the correct type and specification. If you are in any doubt contact your Land Rover Retailer/Authorized Repairer for advice.

Note: In certain territories it is a legal requirement to carry spare bulbs. A replacement bulb kit is available as an approved accessory from your Land Rover Retailer/Authorized Repairer.

    Unblocking washer jets
    CAUTION Do not operate the washer jets during unblocking or adjustment. Windshield washer fluid may cause irritation to the eyes and skin. Always read and observe the washer fluid manufactur ...

    Headlamp removal
      WARNING Do not attempt to change any bulb with the lighting switch on. If the lighting has just been switched off, give the bulbs time to cool down. Handling them in a hot conditio ...

    See also:

    Airbag Readiness Light
    This light shows if there is an electrical problem. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash sensi ...

    License Plate Lamp
    To replace one of these bulbs: 1. Remove the two screws holding each of the license plate lamps to the liftgate trim. 2. Turn and pull the license plate lamp forward through the liftgate trim op ...

    How to use INFINITI controller
    Choose an item on the display by rotating or pushing the center dial 1 upward/ downward, and push the ENTER button 2 for operation. If you push the BACK button3 before the setup is complet ...