Range Rover: ACC malfunction - Adaptive cruise control - Range Rover Owner's ManualRange Rover: ACC malfunction

If a fault occurs during operation of the system in cruise or follow modes, the ACC system will switch off and cannot be used until the fault is cleared. The message DRIVER INTERVENE appears briefly and is then replaced by the message CRUISE NOT AVAILABLE.

If failure of the ACC or any related system occurs at any other time, the message CRUISE NOT AVAILABLE will be displayed. It will not be possible to activate the ACC system in any mode.

Accumulations of dirt, snow or ice on the sensor or cover may inhibit ACC operation. Fitting of a vehicle front protector or metallised badges may also affect ACC operation. If this occurs in ACC cruise /follow mode, the audible alarm sounds and the message DRIVER INTERVENE displays briefly. The message ACC SENSOR BLOCKED will then be displayed.

Note: The same messages may also be displayed while driving on open roads with few objects for the radar to detect.

Clearing the obstruction allows the system to return to normal operation. If the obstruction is present when ACC is inactive (e.g. on initial starting or with the ACC system switched off), the message ACC SENSOR BLOCKED will be displayed.

Tires other than those recommended for your vehicle, may have different sizes. This can affect the correct operation of the ACC.

    Detection beam issues
    Detection issues can occur: 1. When driving on a different line to the vehicle in front. 2. When a vehicle edges into your lane. The vehicle will only be detected once it has moved fully into yo ...

    Forward alert function
    Limited detection and warning of objects ahead, is provided during ACC operation by the ACC DRIVER INTERVENE warning. The forward alert feature additionally provides warnings when ACC is not engag ...

    See also:

    Reporting safety defects
    For USA If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administratio ...

    Throttle and Brake Pedal Adjustment
    The vehicle has adjustable throttle and brake pedals that allow you to change their positions. The switch used to adjust the pedals is located on the center console below the climate control syst ...

    If your vehicle is stolen
    If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufact ...